9 Fabric tank
9 FABRIC TANK
Fabric tank with inclined worm
9.1 General information about the fabric tank
For pellet storage without fabric tank the customer must be provide the sloped floor.
When installing the fabric tank, thanks to its design you are also installing the sloped floor.
Ensure that all structural requirements are strictly satisfied:
• Point 1.3 to 1.3.2 in the introduction
• Point 9.2 to 9.7.3
Inform the owner of the system of any defects that might be present.
The fire safety regulations must be satisfied before commissioning!
9.2 Fabric tank and fuel extractor
Pellets can be supplied from the fabric tank to the KWB Easyfire with the following KWB fuel extractors:
• Inclined worm Type S
• Fan with removal pot Type GL
KWB fuel extractors are described in sections 10 to 16.
MA-Easyfire 10.2008_EN.indd 85MA-Easyfire 10.2008_EN.indd 85 30.03.2009 13:30:14 Uhr30.03.2009 13:30:14 Uhr
To Next Page
Loading...
