17 Pellet stirrer
12.) Install the stirrer disk
First insert the feather key in the shaft groove, and if necessary it must
be carefully struck in with the rubber mallet.
Install the feather key
Insert the stirrer disk with the long shaft end in front onto the gear
unit. On the underside of the gear unit it must be bolted with the fixing
washer, a spring lock washer and a hex bolt.
Place the spacer sleeve on the drive shaft.
Place the stirrer disk on the gear unit
Slide the bearing housing onto the drive shaft. The long part of the
bearing sleeve must be on top. Then place the stirrer cover disk with
the reinforcements on top, on the bearing housing and fasten with the
spring-lock washers and hex bolts.
Install bearing housing + cover disk
The last step is to close the bearing housing with the cover
Seal the bearing housing
13.) Fastening the spring leafs
Fasten the two spring leafs to the suction conveyor system with
washers, spring-lock washers and hex bolts.
Install leaf springs
17.3 FE connection on the burner see point 10.7.
17.4 Final inspection
Ensure that ALL components and connections are correctly installed!
To conclude, ensure that the conveyor system is free of foreign objects!
MA-Easyfire 10.2008_EN.indd 142MA-Easyfire 10.2008_EN.indd 142 30.03.2009 13:31:42 Uhr30.03.2009 13:31:42 Uhr
To Next Page
Loading...
