2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-7
8. Release the lock lever by a finger and
slide the paper feed driving shaft.
9. Remove the paper feed holder by slid-
ing after it turned upward.
Figure 1-5-10
10. Remove the paper feed roller by pulling
out the paper feed roller shaft from the
paper feed holder.
11. Remove upward the pickup roller shaft
by bending the paper feed holder.
12. Remove the pickup roller by pulling out
the pickup roller shaft.
13. Check or replace the paper feed roller
and the pickup roller and refit all the
removed parts.
14. When replacing the new unit,proceed
as follows:
1)Performs maintenance mode U901
(Clr Paper FD Cnt) (see page 1-3-111).
Figure 1-5-11
Paper feed holder
Paper feed driving shaft
Driving shaft lock lever
Pickup roller
Paper feed roller
Paper feed roller shaft
Pickup roller shaft
To Next Page
Loading...
