2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
1-3-4
Operation
panel and
support
equipment
U203 Chk DP Ope Each simulation is operated with DP simple
substance.
U204 Set Card/Counter The presence or absence of a key card
and a key counter is set up.
U207 Chk Panel Key An operation key is checked.
U211 Set EH Connection The presence or absence of a duplex unit
is changed.
U223 Lock panel Ope The operation functions of operation panel
are changed. (Advanced model only)
U243 Chk DP motors Operation of the motor of DP, a clutch, and
a solenoid is checked.
U244 Chk DP Switch The state of the paper detection SW of DP
is displayed.
Mode set-
ting
U250 Mnt Cnt Pre-set The preset value (number of sheets) of a
maintenance cycle is set up.
U251 Clr Mnt Cnt A maintenance counter are displayed and
the data are changed.
U252 Set Dest The destination is set up.
U253 Sel D/S count The copy count methods (double count),
such as a total counter, are set up.
U260 Set Count Mode The timing (feeding or ejection) which a
total count etc. count is changed.
U265 Set Model Dest The consecutive numbers of the OEM are
set up.
U285 Set Svc Sts Page A coverage report output (permission or
failure) is channged.
U326 Set clean Bk Line An announcement (a display -- or undis-
played) when black line is detected is set
up.
U332 Adj Calc Rate The coefficient of the fixed form external
application paper to A4 (or 11x8.5) paper is
set up.
U341 Set Prn Cass The cassette stage only for a printer is set
up.
U343 Set Dup PriMode A default (Duplex copy or Simplex copy) by
a copy is set up.
U345 Set Mnt Time Disp The number of sheets of a check close dis-
play is set up.
U346 Slct Sleep mode A BAM conformity country is set up.
Section
Item
No.
Content of maintenance item Summary
To Next Page
Loading...
