Kyocera FS-1018MFP

System Settings
5-28 ADVANCED OPERATION GUIDE
Low Power Time
The Low Power mode automatically puts the machine into a state of sleep
if no operation has been performed on the machine for a pre-set period of
time (between 1 minute and 240 minutes). Low Power Mode will be shown
on the message display, but everything else on the operation panel will go
out. The factory default setting is for 5 minutes.
To enable copying or scanning again, press any one of the keys on the
operation panel. If the optional document processor is installed on your
machine, copying will be automatically enabled as soon as you place an
original in the document processor.
1
Press [System Menu / Counter]. The Sys. Menu/Count screen displays.
2
Press S or T to select Date/
Timer Set and press [Enter].
The Date/Timer Set screen
displays.
3
Press S or T to select Low
Power Timer and press [Enter].
The Low Power Timer screen
displays.
4
Press S or T to select the time
for the Low Power mode to
engage and press [Enter].
A Completed message displays
and the Date/Timer Set screen
returns.
Sys. Menu/Count.:
System Setting
Date/Timer Set.
Adjust
Exit
Date/Timer Set.:
Summer Time
Reset Timer
Low Power Timer
Exit
Low Power Timer:
(1
10 min
~240)
Cancel