Kyocera FS-1018MFP

Printer Settings
ADVANCED OPERATION GUIDE 3-9
Subnet Mask Setting
Specifies the Subnet Mask configured on the printing system network
component. If the printing system does not automatically assign a usable
default value and the first number in the IP Address is from 192 to 254, then
use 255.255.255.0 as the Subnet Mask.
Use the following procedure to register the Subnet Mask address.
NOTE: If you are not sure of the appropriate Subnet Mask address,
contact your Network Administrator.
1
Access the TCP/IP Settings screen.
2
Press S or T to select Subnet
Mask and press [Enter].
The Subnet Mask screen
displays.
3
Enter the Subnet Mask address using the same procedure used for the IP
Address in steps 3 through 5 of IP Address Setting.
Default Gateway Setting
Use the following procedure to register the Default Gateway address. If
you are not sure of the appropriate Default Gateway address, contact your
Network Administrator.
1
Access the TCP/IP Setting screen.
2
Press S or T to select Default
Gateway and press [Enter].
The Default Gateway screen
displays.
3
Enter the Default Gateway address using the same procedure used for the
IP Address in steps 3 through 5 of IP Address Setting.
TCP/IP Setting:
DHCP
IP Address
Exit
Subnet Mask
*
TCP/IP Setting:
IP Address
Subnet Mask
Exit
Default Gateway