Printer Settings
3-2 ADVANCED OPERATION GUIDE
Network Printing
The following flow identifies the steps needed to prepare the machine for
network printing:
Prepare the environment for a network connection
(Designate IP addresses, etc.)
È
Connect the Network Cable
(Refer to the Basic Operation Guide)
È
Program the required settings using the Operation Panel or COMMAND
CENTER (Refer to this section and to page 6-2.)
Main procedures required:
• Program the appropriate network settings
• Select the Emulation Mode
• Set the number of prints to be made and designate the Original
Placement
•Select Original Quality Mode
• Register the paper sizes for the cassette(s) and MP Tray
È
Install and set up the printer driver
(Refer to KX Printer Driver Guide)
È
Send prints from the application
To Next Page
Loading...
