Kyocera FS-1018MFP

Using COMMAND CENTER
ADVANCED OPERATION GUIDE 6-15
Scanner Page
This section includes settings that apply to the scanning function of the
device, such as default Scan Resolution or Original Placement.
Settings that affect the entire device, such as locking the operation panel,
are found under the Basic page.
In order to attach scanned data file to an e-mail and send it, the SMTP
settings on the Advanced page must be completed.
Scanner> Defaults: Settings Page
The table below provides a summary of the items displayed on the
Scanner Default Settings page.
Item Description
Scan Color/
Exposure
Switches the scanning color and exposure modes
between Full Color/Manual, Grayscale/Manual,
Monochrome/Manual and Monochrome/Auto.
Scan
Resolution
Switches the scanning resolution between 200 × 200,
300 × 300, 400 × 400, and 600 × 600 (dpi). The
maximum resolution using Full Color and Grayscale
modes is 300 dpi. To scan in Full Color or Grayscale
with 400 dpi or 600 dpi resolution, expand the amount
of the internal memory. Refer to Expansion Memory,
Chapter 5, in the Basic Operation Guide.
Optimize for The Original Quality is selected according to the type
of original.
Switches the Original Quality between Text, Photo,
and Text+Photo.
Exposure Switches the exposure mode between Auto and
Manual.
Zoom Switches the Zoom ratio between Auto and 100 %.
The default setting is 100 %.
Original
Placement
Switches between Top Edge to Rear and Top Edge to
Left.
File Name You can change the File Name for the scan data. The
default File Name is doc.
You can also add the time or the job number to the File
Name that you designate here. Refer to File Name
Entry on page 2-20.