Kyocera FS-1018MFP

Printer Settings
ADVANCED OPERATION GUIDE 3-5
Network Settings
Network Settings must be programmed to enable network printing and also
to send e-mail. This section explains the settings required to use the
network functions of the machine.
NOTE: Contact your Network Administrator to ensure you have the
correct information prior to setting the IP Address.
Always restart the machine after Network Settings have been
programmed, to ensure the settings are registered in the machine. For
information refer to Restarting the Machine on page 5-16.
AppleTalk Setting
This setting should be set to On when the machine is connected to an
Apple Macintosh computer.
1
Press [System Menu / Counter]. The System Menu/Count screen
displays.
2
Press S or T to select System
Setting and press [Enter].
The System Setting screen
displays.
3
Press S or T to select Network
Setting and press [Enter].
The Network Setting screen
displays.
4
Press S or T to select AppleTalk
Set and press [Enter].
The AppleTalk Set screen
displays.
*
Sys. Menu/Count.:
Counter
System Setting
Report
Exit
*
System Setting:
Back
Network Setting
Parallel Setting
Exit
Network Setting:
Back
AppleTalk Set.
TCP/IP Setting
Exit