Kyocera FS-1018MFP

Using COMMAND CENTER
ADVANCED OPERATION GUIDE 6-23
Troubleshooting
If problems occurs with COMMAND CENTER, carry out the applicable
checkpoints and procedures indicated in the following tables. If the
problem persists, contact your Service Representative or Authorized
Service Center.
Problem Checkpoint Procedure Reference
I can’t access
COMMAND
CENTER.
Is the power switched on? Switch on the power, wait until it is
in a ready state, and try to access
COMMAND CENTER.
Chapter 3, Basic
Operation Guide
Is the network cable
correctly connected?
Connect the network cable
correctly.
Chapter 3, Basic
Operation Guide
Are the network settings
that are made in this
machine correct?
Perform the network settings from
the operation panel. Contact your
Network Administrator for
information on the appropriate
settings.
page 3-5
Is the IP address for this
machine entered
correctly?
Enter the correct IP address.
Check with your Network
Administrator to make sure the
correct IP address has been
designated for this machine.
page 3-7
Are the LAN (Local Area
Network) settings that are
made in your browser
application correct?
Check the settings made in your
browser application. For details,
refer to the Help function in your
browser application.
-
Has the administrator set
up an IP Filter function?
Access COMMAND CENTER from
an approved IP address.
page 6-17
The SNMP Read
Community settings
function as passwords to
control read and write
access to the device via
SNMP.
Access COMMAND CENTER from
an approved Read Community.
page 6-20
Does the version of your
browser application
support COMMAND
CENTER?
Use a browser application that
supports the COMMAND CENTER.
page 6-2
Characters do not
display correctly in
COMMAND
CENTER.
Does the version of your
browser application
support COMMAND
CENTER?
Use a browser application that
supports COMMAND CENTER.
page 6-2