Using COMMAND CENTER
6-24 ADVANCED OPERATION GUIDE
I can’t access the
Basic, Printer,
Scanner, and
Advanced pages.
Has the administrator set
a password?
Enter the appropriate password. page 6-8
I can’t perform
settings.
Is the printer or scanner
currently in operation?
Settings are not possible while the
printer or scanner is in operation.
Wait until the operation has been
completed.
-
The settings I
made are not
registered.
Did you click on the
Submit button after
making the settings?
After making the desired settings,
click on the Submit button and
move to another page or close the
COMMAND CENTER window.
page 6-9
Did you click on the
Restart button after
making the settings?
Some settings are not
registered until the
machine is restarted.
Restart this machine. All settings
will be registered.
page 6-11
The administrator
has forgotten the
Admin password.
- If the Admin password is forgotten,
reset to factory defaults.
page 6-8
Error is displayed
under the STATUS
indicator
Is there an error message
shown in the message
display?
Follow the appropriate procedure in
the troubleshooting section of the
Basic Operation Guide that
corresponds to the error message.
Chapter 7, Basic
Operation Guide
Warning is
displayed under
the STATUS
indicator
Problem Checkpoint Procedure Reference
To Next Page
Loading...
