Using COMMAND CENTER
6-22 ADVANCED OPERATION GUIDE
sysLocation The MIB-II sysLocation object, usually the location
information of the printing system.
Authenticati
on Traps
Check On to enable or Off to disable the MIB-II
EnableAuthenTrap object. If enabled, an SNMP trap is
generated when an attempt to read or write is made
using an incorrect community name. The trap is sent
to the configured trap address.
Trap
Community
The SNMP trap community name to be used when the
printing system generates a trap.
Trap IP
Address
The IP Address which will receive the trap.
Selected
Errors
Select the events which will cause a trap to be
generated including Add Paper, Low Toner, Add Toner,
Cover Open, Paper Jam, and All Other Errors.
Item Description
To Next Page
Loading...
