EasyManua.ls Logo

Kyocera FS-1018MFP - Page 190

Kyocera FS-1018MFP
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix-18 ADVANCED OPERATION GUIDE
NetBEUI (NetBIOS Extended
User Interface)
An enhanced version of the NetBIOS protocol, it enables the utilization of
more advanced functions on small-scale networks than do other protocols
such as TCP/IP, etc.
Parallel interface With this interface, data transfer between the printer and the computer
takes place in 8-bit chunks. The printer can perform IEEE1284 compatible
bi-directional communications.
PostScript This is a page description language developed by Adobe Systems, Inc. It
enables flexible font functions and highly-functional graphics, allowing
higher quality printing.
PPM (prints per minute) This indicates the number of A4 size printouts made in one minute.
Printer driver The printer driver makes it possible for you to print data created using
application software. The printer driver for the printer is contained on the
CD-ROM supplied with the printer. Install the printer driver on the computer
connected to the printer.
Process unit This is the machine’s main module and contains the photosensitive drum
and developer unit.
Scan Noise Reduction If black lines appear on copies when you feed originals from the Document
Processor (but they do not exist on the originals themselves), this function
will make them less apparent.
Scan to e-mail This is a function for sending scan data files to registered or entered e-mail
addresses.
SMTP (Simple Mail Transfer
Protocol)
This is a protocol for the transmission of e-mail over the Internet or an
intranet. It is used for transferring mail between mail servers as well as for
sending mail from each client to their server.
SNMP (Simple Network
Management Protocol)
This is a protocol for the management of networks that use TCP/IP
(Transmission Control Protocol/Internet Protocol).
Sleep mode This mode is activated after a specified amount of time elapses. The
machine goes into an economy mode and a minimum amount of power is
consumed. You can use the operation panel to change the amount of time
before the machine goes into the Sleep mode. The default setting is 30
minutes.
Status page This lists machine conditions, such as the machine’s memory, the total
number of prints and scans, and paper source settings. You can print the
status page from the operation panel.
Subnet Mask This is a 32-bit numerical value that defines which bits of the IP address
specify the network address and which specify the host address.
TCP/IP (Transmission Control
Protocol/Internet Protocol)
TCP/IP is a suite of protocols designed to define the way computers and
other devices communicate with each other over a network.

Table of Contents

Other manuals for Kyocera FS-1018MFP

Related product manuals