System Settings
5-27
Auto Sleep Timer
The machine has an Auto Sleep Timer that is used to conserve power when the machine is not
copying, scanning, printing, or receiving data. You can adjust the timer timeout time, the length of
time (between 1 minute and 240 minutes) the machine waits before entering auto sleep mode in the
absence of data. The factory default time is 30 minutes.
The machine starts counting auto sleep time after the lower time expires. For example, when the
low power timer timeout is 5 minutes and auto sleep timeout is 10 minutes, the machine enters auto
sleep mode after 15 minutes.
To engage the auto sleep mode manually, Press and hold the Reset/Power key for at least two
seconds. The auto sleep mode will engage immediately. The machine wakes from auto sleep mode
whenever press and hold the Reset/Power key for at least two seconds or a print job is received.
Enabling Auto Sleep
1
Press the System Menu/Counter key. The Sys. Menu/Count screen is displayed.
2
Press the S key or the T key to select Date/Timer
Set and press the Enter key. The Date/Timer Set
screen is displayed.
3
Press the S key or the T key to select Auto Sleep
and press the Enter key. The Auto Sleep screen is
displayed.
4
Press the S key or the T key to select either On or
Off. Press the Enter key. The message display shows
Completed and returns to the Date/Timer Set
screen.
Sys. Menu/Count.:
System Setting
Date/Timer Set.
Adjust
Exit
Date/Timer Set.:
Err. Clear Timer
Err. Clear Timer
Auto Sleep
Exit
Auto Sleep:
Off
On
Cancel
*
To Next Page
Loading...
