Using COMMAND CENTER
6-8
Basic > Network Page
This page allows you to make the settings that are required for network printing and sending e-mail.
For more information, refer to Advanced > Protocols > TCP/IP > General on page 6-12.
Note Always restart this machine after you have completed these settings in order to properly register the
content of those settings in the machine. Refer to Basic > Reset Page on page 6-9.
Basic > Time Page
The current time can be set from the machine’s operation panel and, if a time server is used to
synchronize the time as well, the current time can be adjusted regularly and easily. Enter the IP
address of the time server and click the Synchronize button to synchronize the time.
To set a time difference, click the drop down list for Local Time Adjustment and select your region.
Item Description
Host Name Specifies a name for the printing system network component. This name is
also used as the NetBEUI Printer Name and the SNMP sysName object.
IP Address Assigns the Internet Protocol address on the printing system network
component. Format of the IP Address is four-byte (32-bit) numbers
separated by dots, e.g. 192.168.110.171.
Subnet Mask Specifies the subnet mask configured on the printing system network
component. If the printing system does not automatically assign a usable
default value and the first number in the IP address above is from 192 to
254, then use 255.255.255.0 as the subnet mask.
Default Gateway The IP address of the gateway router for the local network.
DHCP/BOOTP Identifies how the machine obtains its IP configuration: DHCP/BOOTP:
automatic configuration via a BOOTP server or a DHCP server.
Item Description
Current Local Time Displays the time that is currently set in the machine.
Current Universal
Time (UTC/GMT)
Displays the Greenwich Mean Time that is currently set in the machine.
Local Time
Adjustment
Sets a time difference. Click the drop down list and select your region.
Summer Time Switches the Summer Time setting On and Off. Select On in order to have
the Summer Time function applied when the time is synchronized
automatically with a time server. This setting is valid only in the area where
summer time is observed.
Time Server Enter the IP address of the time server with which you want to synchronize
the time.
Synchronize with
Time Server now
Click the Synchronize button to synchronize the registered time with the
designated timer server.
Synchronization
Status
Displays the results of the synchronization operation with the time server.
Synchronization was successful: Last synchronization was successful.
Synchronization was not successful: Last synchronization failed.
To Next Page
Loading...
Need help?
General
