Kyocera KM-1815 - Adjusting Alarms

System Settings
5-16
Adjusting Alarms
The various alarms can be turned on and off and/or the sound volume adjusted. Increasing the
volume of the alarms is especially convenient when the machine is installed in a relatively removed
location. The following shows the various alarms and the available volume settings.
Note The current settings are shown with an asterisk (*).
Item Available Settings Description
Volume
*
0 Off
1 Minimum
2
3 Middle
4
5 Maximum
Adjust the volume of the alarms. To make all alarm
sounds inaudible, select the Off setting. The larger
the setting value, the larger the volume.
Key Conf. Buzzer
*
Off
On
Indicates that the machine has accepted the key
operation that was performed by the user.
Key Fail Buzzer
*
Off
On
Indicates that for some reason the machine is
unable to accept the key operation that was
performed by the user.
Reset Buzzer * Off
On
Indicates that the Reset/Power key was pressed in
order to reset the current settings.
Job End Buzzer * Off
On
Indicates that a corresponding copy, print, or scan
jobs was completed or that the machine has
returned to an operation-ready state.
Ready Buzzer * Off
On
Indicates that the machine is in an operation-ready
state.
Warning Buzzer * Off
On
Indicates that in its current state the machine is
unable to perform the corresponding job.
This setting applies when one of the following
messages appears on the message display.
• Close Document Processor.
• Insert Cassette 1.
• KPDL error. Job is ended.
• Load Paper in Cassette1 (Cassette2,
MP Tray, or Document Processor).
• Memory overflow. Part of the job
end is printed.
• Place original and press Start key.
• Print overrun. This page isn’t
complete.
• Remove original from Document
Processor.
• Send error.
• Toner low.