3-1
3 Printer Settings
This chapter explains the procedures to make the various settings that are required in
order to use the printer functions of the machine.
The settings that are required to use the machine as a network printer can be made from
either the operation panel or using COMMAND CENTER.
The procedures in this chapter specifically explain how to make the corresponding
settings from the operation panel.
This chapter explains the following topics:
• Using the Machine as a Network Printer
• Parallel Setting
• Network Settings
• Setting the Emulation Mode
• COMMAND CENTER
Note
For the procedures to make settings using COMMAND CENTER, refer to Using COMMAND
CENTER on page 6-1.
To Next Page
Loading...
