Kyocera KM-1815 - Reporting the End of Copying

Copying Functions
1-24
Reporting the End of Copying
This function notifies you by e-mail when copying has been finished.
Note In order to use this function, you must perform the appropriate e-mail settings in advance.
The following is an example of the information that is sent by e-mail.
1
Press the Copy key. The copy basic screen is displayed.
2
Press the Function key.
3
Press the S key or the T key to select Job End
Report and press the Enter key. The Job End
Report screen is displayed.
4
Press the S key or the T key to select On. Press the
Enter key.
To: h_pttr@owl-net.net
Subject: 1234 event mail
Job No. : 2
Result : OK
End Time : 04/15/2004 14:56
File Name : doc041520041456
Job Type : Copy
------------------------------------------------
1234
[00:c0:ee:d0:01:14]
------------------------------------------------
*
Function:
Job End Report
Continuous Scan
File Name Entry
Exit
*
Job End Report:
*Off
On
Cancel