Kyocera KM-1815 - DHCP Setting; IP Address Setting

Printer Settings
3-6
4
To use TCP/IP, select On and press the Enter key. The
message display shows Completed and returns to the
TCP/IP Setting screen.
DHCP Setting
DHCP (Dynamic Host Configuration Protocol) provides a mechanism for delivering IP configuration
parameters, including IP address, Subnet Mask, etc. to devices on an IP network. DHCP alleviates
the administrative burden of managing individual IP addresses.
Turn this setting On when DHCP is to be used.
1
Access the TCP/IP Setting screen.
2
Press the S key or the T key to select DHCP and
press the Enter key. The DHCP screen is displayed.
3
To use DHCP, select On and press the Enter key. The message display shows Completed and
returns to the TCP/IP Setting screen.
IP Address Setting
Perform the following procedure to register the IP address.
Notes • The IP address that should be registered here will differ depending upon your network
environment. Check with your network administrator before performing this setting.
• If you use the following procedure to manually register the IP address, be sure to turn the
DHCP setting Off and the TCP/IP setting On.
1
Access the TCP/IP Setting screen.
2
Press the S key or the T key to select IP Address
and press the Enter key. The IP Address screen is
displayed.
*
TCP/IP:
On
Off
*
Cancel
*
TCP/IP Setting:
Back
TCP/IP
DHCP
Exit
*
TCP/IP Setting:
TCP/IP
DHCP
Exit
IP Address