58 General Maintenance
Figure 3-41
Protective panels
NOTE: On some trucks, especially those with a single split crusher panel, the crusher panel deflector
also needs to be removed (see Figure 3-42).
Once the protective covers are removed, you will be able to access the area where the chute
cylinder and the rear end section of the chute shaft are.
Figure 3-42
Hopper rear side
4 g. Remove the cotter pin (see Figure 3-43) that holds the cylinder pin in.
Protective cover
Crusher panel
Crusher panel
deflector
To Next Page
Loading...
Need help?
General
