Step 3. Align the tabs on both sides of the air baffle with the corresponding slots on both sides of the
chassis. Then, lower the air baffle into the chassis and press the air baffle down until it is securely
seated.
Note: The illustrated air baffle is a standard air baffle. The installation method is the same for the
GPU air baffle. For more information, see “Install a GPU adapter” on page 218.
Figure 151. Installation of the standard air baffle
After you finish
1. If you have removed a RAID super capacitor module, reinstall it and connect it to the RAID adapter with
the extension cable. See “Install a super capacitor module on the air baffle” on page 319.
2. If you have removed a GPU adapter, reinstall it. See “Install a GPU adapter” on page 218.
3. Complete the parts replacement. See “Complete the parts replacement” on page 381.
200
ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
