Figure 168. Installing the riser assembly
a. Align the riser card with the PCIe slot on the system board. Carefully press the riser card
straight into the slot until it is securely seated.
b. If you are installing a full-length GPU adapter, open the blue latch on the GPU air baffle and fix
the end of the GPU adapter. Then, close the blue latch.
c. Tighten the screw to fix the riser cage.
Step 6. (Optional) If you are installing a GPU adapter on riser 3 assembly, connect the GPU power cable to
GPU power connector on the system board. See “GPUs” on page 73.
220
ThinkSystem SR650 V2Maintenance Manual
To Next Page
Loading...
