Install a hot-swap drive . . . . . . . . . . 227
Front drive backplane replacement . . . . . . . 229
Remove the front 2.5-inch drive backplane . . 229
Install the front 2.5-inch drive backplane . . . 230
Remove the front 3.5-inch drive backplane . . 234
Install the front 3.5-inch drive backplane . . . 235
Internal CFF adapter replacement. . . . . . . . 238
Remove an internal CFF adapter . . . . . . 238
Install an internal CFF adapter . . . . . . . 239
Intrusion switch replacement . . . . . . . . . 240
Remove the intrusion switch . . . . . . . . 240
Install the intrusion switch . . . . . . . . . 241
M.2 adapter and M.2 drive replacement . . . . . 244
Remove the M.2 adapter and M.2 drive. . . . 245
Adjust the retainer on the M.2 adapter . . . . 247
Install the M.2 adapter and M.2 drive. . . . . 248
Memory module replacement . . . . . . . . . 250
Remove a memory module . . . . . . . . 250
Memory module installation rules and
order . . . . . . . . . . . . . . . . . 253
Install a memory module . . . . . . . . . 269
Middle drive backplane and drive cage
replacement . . . . . . . . . . . . . . . . 270
Remove the middle drive cage . . . . . . . 271
Remove the middle drive backplane . . . . . 274
Install the middle drive backplane . . . . . . 275
Install the middle drive cage . . . . . . . . 276
OCP 3.0 Ethernet adapter replacement . . . . . 277
Remove the OCP 3.0 Ethernet adapter . . . . 277
Install the OCP 3.0 Ethernet adapter . . . . . 279
PCIe adapter and riser assembly replacement . . . 282
Remove a PCIe adapter and riser
assembly . . . . . . . . . . . . . . . 284
Install a PCIe adapter and riser assembly . . . 286
Power supply unit replacement . . . . . . . . . 288
Safety precautions . . . . . . . . . . . . 288
Remove a power supply unit . . . . . . . . 291
Install a power supply unit . . . . . . . . . 294
Processor and heat sink replacement (trained
technician only) . . . . . . . . . . . . . . . 297
Remove a processor and heat sink . . . . . 297
Separate the processor from carrier and heat
sink. . . . . . . . . . . . . . . . . . 299
Install a processor and heat sink . . . . . . 301
Rack latches replacement . . . . . . . . . . . 306
Remove the rack latches . . . . . . . . . 306
Install the rack latches . . . . . . . . . . 309
RAID super capacitor module replacement . . . . 313
Remove a super capacitor from the
chassis . . . . . . . . . . . . . . . . 313
Install a super capacitor on the chassis . . . . 316
Remove a super capacitor module from the air
baffle . . . . . . . . . . . . . . . . . 318
Install a super capacitor module on the air
baffle . . . . . . . . . . . . . . . . . 319
Remove a super capacitor module from the
middle 2.5-inch drive cage. . . . . . . . . 320
Install a super capacitor module on the middle
drive cage . . . . . . . . . . . . . . . 322
Rearwall bracket replacement . . . . . . . . . 322
Remove a rearwall bracket. . . . . . . . . 325
Install a rearwall bracket. . . . . . . . . . 327
Rear 2.5-inch drive backplane and drive cage
replacement . . . . . . . . . . . . . . . . 329
Remove the rear 2.5-inch drive cage . . . . . 329
Remove the rear 2.5-inch drive backplane. . . 330
Install the rear 2.5-inch drive backplane . . . 331
Install the rear 2.5-inch drive cage . . . . . . 333
Rear 3.5-inch drive backplane and drive cage
replacement . . . . . . . . . . . . . . . . 336
Remove the rear 3.5-inch drive cage . . . . . 336
Remove the rear 3.5-inch drive backplane. . . 338
Install the rear 3.5-inch drive backplane . . . 338
Install the rear 3.5-inch drive cage . . . . . . 340
Rear 7mm drive backplane and drive cage
replacement . . . . . . . . . . . . . . . . 342
Remove the 7mm drive cage . . . . . . . . 342
Remove the 7mm drive backplanes . . . . . 344
Install the 7mm drive backplanes . . . . . . 346
Install the 7mm drive cage . . . . . . . . . 347
Security bezel replacement . . . . . . . . . . 350
Remove the security bezel . . . . . . . . . 350
Install the security bezel. . . . . . . . . . 352
System board replacement (trained technician
only) . . . . . . . . . . . . . . . . . . . 354
Remove the system board . . . . . . . . . 354
Install the system board . . . . . . . . . . 357
Update the machine type and serial
number . . . . . . . . . . . . . . . . 359
Enable TPM . . . . . . . . . . . . . . 360
Enable UEFI Secure Boot . . . . . . . . . 362
System fan replacement . . . . . . . . . . . 364
Remove a system fan. . . . . . . . . . . 364
Install a system fan. . . . . . . . . . . . 366
System fan cage replacement . . . . . . . . . 368
Remove the system fan cage . . . . . . . . 368
Install the system fan cage. . . . . . . . . 370
Serial port module replacement . . . . . . . . 372
Remove a serial port module . . . . . . . . 372
Install a serial port module . . . . . . . . . 373
Top cover replacement . . . . . . . . . . . . 376
Remove the top cover . . . . . . . . . . 376
Install the top cover . . . . . . . . . . . 378
ii ThinkSystem SR650 V2Maintenance Manual