Contents
8200SHB0199
v
Part D
7 Configuration 7-1..............................................
7.1 8201BB operating module 7-2.........................................
7.2 Structure of the operating program 7-4...................................
7.2.1 Operating level 7-4........................................
7.2.2 Code level 7-4............................................
7.2.3 Parameter level 7-5........................................
7.3 Change and store parameters 7-5.......................................
7.3.1 Change and store parameters with the 8201BB operating module 7-6.....
7.3.2 Change and store parameters with fieldbus modules. 7-8..............
7.3.3 Dynamic parameter change 7-8...............................
7.4 Operating functions 7-9..............................................
7.4.1 Operating mode 7-9........................................
7.4.2 Working with parameter sets 7-10...............................
7.4.3 Change parameter set via DC-bus voltage 7-12.....................
7.4.3.1 AC-motor braking by means of parameter set changeover 7-12
7.4.3.2 Automatic parameter set changeover for controlled
deceleration in the event of mains failure 7-13...........
7.5 Control functions 7-15................................................
7.5.1 Speed range (fdmin, fdmax) 7-15...............................
7.5.2 Acceleration and deceleration times Tir, Tif 7-16.....................
7.5.3 Current limit values (Imax limit values) 7-17........................
7.5.4 Current limitation controller (Imax controller) 7-18....................
7.5.5 Control mode 7-19.........................................
7.5.6 V/f characteristic 7-22.......................................
7.5.6.1 V/f-rated frequency fdr 7-22........................
7.5.6.2 Vmin setting 7-24................................
7.5.7 Configuration 7-26..........................................
7.5.8 Motor data detection 7-27....................................
7.5.9 Running optimisation 7-28....................................
7.5.9.1 Slip compensation 7-28...........................
7.5.9.2 Chopper frequency 7-29...........................
7.5.9.3 Oscillation damping 7-31..........................
7.5.9.4 Ramp function generator S-shape 7-32................
7.5.9.5 Skip frequencies 7-33.............................
7.5.10 PID controller as process controller 7-34..........................
7.5.10.1 Reset integral component and influence 7-38............
7.5.10.2 Setpoint selection for the process controller 7-38..........
7.5.10.3 Frequency precontrol 7-39.........................
7.5.10.4 Frequency setting range 7-39.......................
7.5.11 Setpoint input 7-40.........................................
7.5.11.1 Analog setpoint input 7-40.........................
7.5.11.2 Setpoint input using the keypad 7-42..................
7.5.11.3 Setpoint input via JOG frequencies 7-43................
7.5.11.4 Setpoint input via function ”Motor potentiometer” 7-44......
7.5.11.5 Setpoint input via of the function ”Motor potentiometer in
combination with JOG value” 7-46....................
7.5.11.6 Setpoint sum 7-47...............................
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
