Lenze 8200 - Page 9

Contents
8200SHB0199iv
Part C
5 Commissioning 5-1............................................
5.1 Before switching on 5-1..............................................
5.2 Short commissioning (factory setting) 5-2..................................
5.2.1 Switch-on sequence 5-2.....................................
5.2.2 Factory setting of the most important drive parameters 5-2............
5.3 Adapt machine data 5-3..............................................
5.3.1 Determine speed range (fdmin, fdmax) 5-3........................
5.3.2 Setting of acceleration and deceleration times (Tir, Tif) 5-4.............
5.3.3 Setting of current limit values (Imax limits) 5-5......................
5.4 Optimisation of the operating behaviour 5-6................................
5.4.1 Select control mode 5-6.....................................
5.4.2 Optimising operating modes 5-8...............................
5.4.2.1 Optimising motor-current control (C014 = -4-) 5-8.......
5.4.2.2 Optimise V/f-characteristic control with auto boost
(C014 = -0-/-1-) 5-10............................
5.4.2.3 Optimise V/f-characteristic control with constant Vmin boost
(C014 = -2-/-3-) 5-12............................
5.4.2.4 Normalisation of an application datum 5-15.............
5.4.3 Operation with PID controller 5-16...............................
5.5 Application examples for PID controllers 5-18................................
5.5.1 Pump application with pressure control 5-18........................
5.5.2 Pump application with level control 5-21...........................
5.5.3 Dancer-position control (line drive) 5-23...........................
5.5.4 Air conditioning system 5-26...................................
6 During operation 6-1...........................................
6.1 Operating information 6-1............................................
6.1.1 General 6-1..............................................
6.1.2 822X/824X 6-2...........................................
6.1.3 8218-V003 6-2...........................................
6.2 Display of the controller status 6-2......................................
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com