Lenze L-force 9400 Series - Page 228

9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
228 L EDS94ARNExxxx EN 2.3 - 06/2014
Electronic nameplate: Data loaded [0x007b0030]
Electronic nameplate: Not found [0x007b0031]
Electronic nameplate: Encoder protocol unknown [0x007b0032]
Electronic nameplate: Encoder signal unknown [0x007b0033]
Internal communication error (DMA) [0x007b0034]
Internal communication error (MCTRL host) [0x007b0036]
PLC configuration invalid [0x007b0037]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
New electronic nameplate (ENP) has been found. - (Information only)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Electronic nameplate (ENP) is not available. - (Information only)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The connected filter with feedback is not supported by
the device firmware.
Check device dimensioning.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The connected filter with feedback is not supported by
the device firmware.
Check device dimensioning.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error. Please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error. Please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An invalid control configuration has occurred. Load another application.