Lenze L-force 9400 Series - Page 227

EDS94ARNExxxx EN 2.3 - 06/2014 L 227
9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
Brake resistor: I²xt overload [0x007b001d]
Brake transistor: Overcurrent [0x007b0021]
Failure of mains phase L1 [0x007b002d]
Failure of mains phase L2 [0x007b002e]
Failure of mains phase L3 [0x007b002f]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Too frequent and too long brake operations. • Check drive dimensioning.
• Check parameter setting (C00129
, C00130, C00131).
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Brake chopper short circuit/earth fault detected. Check brake chopper cable and brake resistor.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Interruption of phase L1 of the mains cable.
• Up to software version V02.00.19 a fault is reported if
a mains phase failure occurs.
• From software version V02.00.20 a trouble is reported
for mains phase failures < 500 ms. If the mains phase
failure is pending longer than 500 ms, the device
changes to the "Fault" status.
If the fault is pending longer and the device reports a
fault, check the cabling between the regenerative power
supply module and the mains.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Interruption of phase L2 of the mains cable.
• Up to software version V02.00.19 a fault is reported if
a mains phase failure occurs.
• From software version V02.00.20 a trouble is reported
for mains phase failures < 500 ms. If the mains phase
failure is pending longer than 500 ms, the device
changes to the "Fault" status.
If the fault is pending longer and the device reports a
fault, check the cabling between the regenerative power
supply module and the mains.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Interruption of phase L3 of the mains cable.
• Up to software version V02.00.19 a fault is reported if
a mains phase failure occurs.
• From software version V02.00.20 a trouble is reported
for mains phase failures < 500 ms. If the mains phase
failure is pending longer than 500 ms, the device
changes to the "Fault" status.
If the fault is pending longer and the device reports a
fault, check the cabling between the regenerative power
supply module and the mains.