Lenze L-force 9400 Series - Page 237

EDS94ARNExxxx EN 2.3 - 06/2014 L 237
9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
File ProjectSelection.dat is invalid [0x008c0006]
File ProjectList.dat is invalid [0x008c0007]
File DeviceCFG.dat is invalid [0x008c0008]
Project not loaded [0x008c0009]
Project not available [0x008c000a]
Required licence missing [0x008c000b]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Reformat memory module (C00002="1030") and repeat
project download.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Reformat memory module (C00002="1030") and repeat
project download.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Reformat memory module (C00002="1030") and repeat
project download.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Application could not be loaded because of a file error. Load new or different application.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Application not available. • Download application with the Engineer
• Switch off regenerative power supply module and use
another memory module with an application.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Memory module could not be initialised. Two possibilities:
• Use the Engineer to download and activate an
application suitable for the memory module.
• Switch off regenerative power supply module and
insert another memory module that is suitable for the
application.