EDS94ARNExxxx EN 2.3 - 06/2014 L 265
9400 regenerative power supply module | Parameter setting
Parameter reference
10 Parameter reference
All parameters for parameterising or monitoring the regenerative power supply module
are stored in so-called "codes".
The codes are numbered and designated by a "C" in front of the code, e.g. "C00002".
For the sake of clarity, some codes contain "subcodes" for saving parameters. This
documentation uses a slash "/" as a separator between code and subcode, e.g. C00118/
3".
Parameters which are only available from a certain software version of the regenerative
power supply module onwards, are annotated accordingly in the parameter description
("From software version Vx.x onwards").
The parameter descriptions are based on software version V2.
Tip!
For quick reference of a parameter with a certain name simply use the index of this
online documentation. The index always contains the corresponding code in
parentheses behind the name.
For general information on how to read and change parameters, please see the
online documentation for the »Engineer«.
To Next Page
Loading...
Need help?
General
