Lenze L-force 9400 Series

9400 regenerative power supply module | Parameter setting
Parameter reference
Structure of the parameter descriptions
268 L EDS94ARNExxxx EN 2.3 - 06/2014
10.1.3.1 Parameters with setting range
Description structure
Parameter setting in the »Engineer«
In the »Engineer«, parameters are set by entering the desired value into the input field:
10.1.3.2 Parameters with selection list
Description structure
Parameter setting in the »Engineer«
In the »Engineer«, a list field is used for parameter setting:
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Setting range (min. value | unit | max. value) Lenze setting
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Selection list (Lenze setting printed in bold)
1
2
3
 Read access  Write access  CINH  PLC STOP  No transfer