Lenze L-force 9400 Series - Page 279

EDS94ARNExxxx EN 2.3 - 06/2014 L 279
9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C00076
C00076
C00077
C00078
C00079
C00084
C00085
C00099
Parameter | Name:
C00076 | Current contr. reset time
Data type: UNSIGNED_32
Index: 24499
d
= 5FB3
h
Note: This parameter is only effective in closed-loop operation (in preparation).
Setting range (min. value | unit | max. value) Lenze setting
0.01 ms 2000.00 50.00 ms
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00077 | Service code
Data type: UNSIGNED_32
Index: 24498
d
= 5FB2
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C00078 | Service code
Data type: UNSIGNED_32
Index: 24497
d
= 5FB1
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C00079 | Service code
Data type: UNSIGNED_8
Index: 24496
d
= 5FB0
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C00084 | Filter resistance
Data type: UNSIGNED_32
Index: 24491
d
= 5FAB
h
Note: This parameter is only effective in closed-loop operation (in preparation).
Setting range (min. value | unit | max. value) Lenze setting
0.0000 Ohm 125.0000 0.2000 Ohm
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10000
Parameter | Name:
C00085 | Filter inductance
Data type: UNSIGNED_32
Index: 24490
d
= 5FAA
h
Note: This parameter is only effective in closed-loop operation (in preparation).
Setting range (min. value | unit | max. value) Lenze setting
0.000 mH 500.000 5.000 mH
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1000
Parameter | Name:
C00099 | Firmware version
Data type: VISIBLE_STRING
Index: 24476
d
= 5F9C
h
Format: "xx.xx.xx.xx" (main version, subversion, release version, build number)
 Read access  Write access  CINH  PLC STOP  No transfer