9400 regenerative power supply module | Parameter setting
Device interface
Device commands
38 L EDS94ARNExxxx EN 2.3 - 06/2014
Activating device commands via the "Device commands" dialog box
All device commands of the regenerative power supply module are available in the
»Engineer« in the Device Commands dialog box:
The Device Commands dialog box can be opened by clicking on the setting of C00002
on the All Parameters tab.
During and after the execution of the device command, the processing status is
displayed in the Device Commands dialog box:
Note!
If you click on a device command in the list field of the Device Commands dialog
box, the corresponding device command is executed immediately!
To Next Page
Loading...
