3-2. Opening, closing and locking the doors
z Close
Press the switch on the lower part of
the back door.
The power back door automatically closes.
Pressing the switch while the power
back door is operating will stop the opera-
tion. When the switch is pressed
again during the halted operation, the back
door will perform the reverse operation.
z Close the back door and lock all
doors after moving away from the
back door (close & lock [Walk-
Away] function)
Close all of the doors except the
back door, carrying an electronic
key and press the switch on
the lower part of the back door.
A different buzzer than the normal one will
sound and the close & lock (Walk-Away)
function will go into standby.
While the buzzer is sounding, move
away from the back door.
When the sensor detects that you are
away from the back door, the emergency
flashers will flash (on some models), and
the buzzer will sound. Depending on the
direction of moving away from the back
door, the location and how to hold the
electronic key or circumstances, it may not
be detected properly.
All the doors other than the back door will
be locked, and after the back door is
closed, the back door will also be locked.
When all the doors have been closed and
locked, the buzzer (if equipped) will sound
and the emergency flashers will flash.
(oP.143)
The standby state is canceled if you do not
move away from the back door for 30
minutes. To operate the function again,
perform the procedure again from the
beginning.
If you approach the back door carrying the
electronic key, the back door operation
will stop, all the doors will be unlocked, and
the buzzer (if equipped) will sound and the
emergency flashers will flash. (oP.143)
If the switch is pressed after the
back door operation has stopped, the
close & lock (Walk-Away) function will go
into standby again.
z Close the back door and lock all
doors (close & lock function)
*
To Next Page
Loading...
