3
3-6. Favorite settings
Before driving
Check that the shift lever is in P.
Turn the engine switch to ON.
Adjust the driver’s seat, steering
wheel, outside rear view mirrors
and head-up display (if equipped)
to the desired positions.
While pressing the “SET” button, or
within 3 seconds after the “SET”
button is pressed, press button “1”,
“2” or “3” until the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
will be overwritten.
Q Seat positions that can be memorized
(oP.167)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
Q In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
Check that the shift lever is in P.
Turn the engine switch to ON.
Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
Q To stop the position recall operation
part-way through
Perform any of the following:
O Press the “SET” button.
O Press button “1”, “2” or “3”.
O Operate any of the seat adjustment
switches (only cancels seat position
recall).
O Operate the tilt and telescopic steering
control switch (only cancels steering
wheel position recall).
Q While the power easy access system
is operating and the steering wheel
and seat is moving
Be careful not to get body parts or lug-
gage caught. Failure to do so may cause
an injury or damage to the luggage.
Recording a driving position into
memory button
Q Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
To Next Page
Loading...
