4-5. Using the driving support systems
and press the easy access mode switch
on the Front Multi Operation Panel.
When the easy access mode is in on, the
indicator on the switch and the easy
access mode indicator on the meter
comes on.
If the engine switch is turned off within
approximately 30 seconds after the vehi-
cle is stopped while easy access mode is
on, the vehicle height is lowered automati-
cally.
When the vehicle begins to lower, a
buzzer will sound twice. The easy access
mode indicator display will come on while
the vehicle is lowering to indicate that the
vehicle is lowering.
When the operation is complete, the easy
access mode indicator will turns off.
Q Operation conditions of the easy access
mode
O The easy access mode is operational
when all of the following conditions are
met:
• The vehicle height mode is in N mode.
• The vehicle is stopped on a flat surface.
• The shift lever is in P.
• The side doors and back door are not
opened after the vehicle is stopped.
O When press the height select switch
, the vehicle lowering operation will
cancel and the vehicle height will raise
again.
Q In the following cases the easy access
mode will not operate
The easy access mode does not operate
when the suspension fluid temperature
drops below -15°C (5°F).
Press the height control OFF switch on
the Front Multi Operation Panel while
the vehicle is stopped.
The indicator on the switch will come
on and the OFF indicator will display on
the AHC display.
When the height control OFF indicator is
displayed, the vehicle height will not
change even if the height select switch is
operated.
Press the switch again to turn the system
back on.
Q Operating conditions of the AHC
O The engine must be running.
A
Disabling the height control
To Next Page
Loading...
