1-2. Child safety
sure your seat belt fits snugly across
your shoulder and low on your hips. If it
does not, or if it interferes with the child
restraint, move to a different position.
Failure to do so may result in death or
serious injury.
The child restraint systems mentioned in
the table may not be available outside the
INDIA.
z When installing a child restraint in
the rear seats, adjust the front seat
so that it does not interfere with the
child or child restraint system.
z When installing a child seat with
support base, if the child seat inter-
feres with the seatback when latch-
ing it into the support base, adjust
the seatback rearward until there is
no interference.
z When installing a forward-facing
child seat, if there is a gap between
the child seat and the seatback,
adjust the seatback angle until good
contact is achieved.
z If the seat belt shoulder anchor is
ahead of the child seat belt guide,
move the seat cushion forward.
z When installing a junior seat, if the
child in your child restraint system is
in a very upright position, adjust the
seatback angle to the most comfort-
able position. And if the seat belt
shoulder anchor is ahead of the
child seat belt guide, move the seat
cushion forward.
Q Installing child restraint system
using a seat belt
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
If installing the child restraint sys-
tem to the front passenger seat is
unavoidable, refer to P.91 for the
front passenger seat adjustment.
Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child
seat and the seatback, adjust the
seatback angle until good contact
is achieved.
If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
To Next Page
Loading...
