Lightware UMX-TPS-TX100 Series

5. Software Control - Lightware Device Controller UMX-TPS-TX100 series – User's Manual 56
Ports Section for the UMX-TPS-TX140-Plus and WP-UMX-TPS-TX130-US Models
Infra tab - Ports window for the UMX-TPS-TX140-Plus model
The user can set the name and command injection port to each sources and destinations. For more details
about IR interface see the IR Interface section.
The following settings are also available:
▪ Port name;
▪ 
▪ Port number;
▪ 
▪ Message sending function (little-endian pronto hex code). For more details see the next section;
▪ Reload Factory Default Settings.

Copy the raw, little endian-format IR code into the Send Pronto HexSend button.
The maximum length of the code can be 765 characters (765 bytes). For more details about the accepted IR
code formats, see Sending Pronto Hex Codes in Little-endian Format via IR Port section.

the following parameters: Category: Infra; Expression: Send pronto hex; Port: D1; Pronto hex: <custom_code>
In the Event Manager, the maximum length of the code can be 184 characters (184 bytes).
Sending Pronto
Hex Codes in Big-endian Format via IR Port section.
Clear all IR codes




