LINET Essenza 300

D9U001EZ3-0101_00162
16.1 Passive Mattress
Compatible Passive Mattresses are equipped with straps intended for xing mattress on the Mattress support platform.
Symbols on the mattress wash label serve as instructions for cleaning the mattress cover.
16.2 Active Mattress
WARNING!
Follow instructions for use of a compatible active mattress carefully!
CAUTION!
Risk of material damage due to an incorrect xation of compatible active mattress on the mattress support
platform!
► Adjust the bed to maximum Cardiac Chair Position before xing all the straps of the inated mattress to the
mattress support platform!
Installation instructions:
► Remove any existing mattress.
► Observe mattress dimensions and its orientation before putting it on the Mattress support platform.
► Place SCU on the foot board of the bed or on the oor.
► Fix mattress on the Mattress support platform with straps.
16.3 Integrated Mattress (Air2Care IN)
WARNING!
Risk of injury due to incorrect use!
► Follow instructions for use of compatible integrated mattress system carefully!
CAUTION!
Risk of material damage due to an incorrect xation of compatible integrated mattress on the mattress supp-
ort platform!
► Adjust the bed to maximum Cardiac Chair Position before xing all the straps of the inated mattress to the
mattress support platform!
CAUTION!
Material damage due to incorrect installation of SCU!
► If the SCU does not come factory-tted, have it installed by a service engineer authorised by LINET ®.
WARNING!
Risk of injury due to incorrect use!
► When the Plastic Siderails are lowered, you may need to lift the mattress to access the CPR valve fully.
WARNING!
Risk of material damage due to incompatibility!
► Ensure the Air2Care IN compressor (integrated SCU) is compatible with local power supply each time the
SCU was maintained or replaced.
Service technician is responsible for meeting this requirement.