D9U001EZ3-0101_00
35
5.5 Electromagnetic Compatibility
Bed is intended for hospitals except for near active HF surgical equipment and the RF shielded room of a medical system
for magnetic resonance imaging, where the intensity of EM disturbances is high.
Bed has dened no essential performance.
5.5.1 Manufacturer instructions - electromagnetic emissions
Emission Test Compliance
RF emissions
CISPR 11
Group 1
RF emissions
CISPR 11
Class B
Harmonic emissions
IEC 61000-3-2
Class A
Voltage uctuations / icker emissions
IEC 61000-3-3
Complies
WARNING!
It is recommended to avoid the use of this device next to or in block with other device, because it could lead
to improper operation. If such use is needed, this device and the other equipment should be under surveillan-
ce to verify proper operation.
WARNING!
Use of the accessories, converters and other cables, than specied and provided by manufacturer of this bed
could lead to increase of electromagnetic emission or lower the electromagnetic immunity of this bed and
lead to improper operation.
WARNING!
Mobile RF communication device (including end use devices like antenna cables and external antenna) should
not be used closer than 30 cm (12 inches) from any part of this stetcher Essenza 300, including cables speci-
ed by manufacturer. Otherwise this could lead to deterioration of functionality of this bed.
WARNING!
Do not overload the bed (SWL), respect the duty cycle (INT. on the serial label) and consider chapter Mainte-
nance (see „20 Maintenance“ on the page 198) in order to maintain the basic safety with regard to electro-
magnetic disturbances for the expected service life.
List of used cables:
► Mains cable, maximum length 5 m
To Next Page
Loading...
