Loop Telecom IP6610 - Page 132

Chapter 21 Appendix A: Operation Commands
109
Unit Commands
Command
Parameters Description BR
RT
Level
l2_protocol
display WAN1 layer 2 protocol V V OP
nat
show mode of network address translation --
V OP
pvc pvc_no
1-10
param_type
all/ ip/ routing/ mode/ dlci/ nat/ time_slot/
bandwidth
show frame relay pvc settings V V OP
queue
show current queue status
routing_protocol
show WAN1 routing protocol
statistics
show WAN1 traffic statistics
time_slot
show WAN1 timeslot assignment V V OP
show svlan port
show each port’s svlan interface state
V --
OP
show svlan table
show SVLAN table
V --
OP
show svlan state
show SVLAN state
V --
OP
table
start: initial entry in the VLAN table
end: final entry in the VLAN table
display the VLAN table
V --
OP
port
Interface name
lan/,wan1/
wan1 pvc1/….
display VLAN information for all bridge interfaces
or one specific interface
V --
OP
show vlan
state
display VLAN information about the VLAN state,
Mgmt. VID, etc.
V --
OP
traceroute
address
xxx.xxx.xxx.
xxx
[-w timeout]
1-5000
h [max_hops]
1-50
Issue trace route requests
(using ICMP request)
--
V OP
upload configurati
on
ip
xxx.xxx.xxx.xxx
name
file_name
upload current working system configuration
(not saved config in flash)
V V Admin