Loop Telecom IP6610 - Page 131

Chapter 21 Appendix A: Operation Commands
108
Unit Commands
Command
Parameters Description BR
RT
Level
show fwinfo
show system firmware information
(information contains:
boot-strapper version,
bank1 version,
bank2 version,
active bank number)
V V OP
show hwinfo
show system hardware information
-hw version
-serial number
-wan interface:DS1/e1 (BNC/TP)
-mac address
V V OP
show lan1 ip
show LAN1 IP address --
V OP
statistics [update period]
nn
show lan1 statistics
show a network interface’s statistics
(normal mode)
V V OP
log
show event log V V OP
mac
display MAC table regardless of the VLAN state V --
OP
nat [mode]
nat/napt
show NAT setting --
V OP
route [all]
show static routing table --
V OP
serial
show device’s serial number V --
OP
snmp
show SNMP setting V --
OP
show rate_limit
shows all policies user ever entered for WAN
interface
V V OP
sntp
show SNTP configuration and status V V OP
term
show terminal parameters V V OP
time
show current system date time V V OP
show
all
show all WAN1 information V V OP
frame_relay
show current frame relay settling V V OP
interface_mode
show WAN1 interface mode V V OP
ip
show WAN1 IP address --
V OP