Chapter 21 Appendix A: Operation Commands
127
Command: >set alarm
Syntax: set alarm type setting
Explanation: Enable or disable an alarm type
Parameters: type clock_loss/rai/ais/los/lof/bpv/es/uas/css/
etherneDS1/ethernet2/ethernet3/ethernet4/
all (use all to select all alarm)
setting enable/disable
Command: >set alarm BPV/ES/UAS/CSS threshold
Syntax: set alarm c threshold value
Explanation: Set alarm threshold for BPV, ES, UAS or CSS
Parameters: value Alarm Threshold value
BPV 10E- (5, 6, 7, 8, 9)
ES (1 ~ 900)
UAS (1 ~ 900)
CSS (1 ~ 900)
Command: >set bridge ip
Syntax: set bridge ip ip_addr net_mask
Explanation: Set the management ILP address for the bridge.
Parameters: ip the ip address of the tftp server
mask subnet mask
Command: >set bridge gateway
Syntax: set bridge gateway ip_addr
Explanation: sets the gateway address for the management ip address
Parameters: ip_addr gateway IP address
Command: >set bridge crc
Syntax: set bridge crc setting
Explanation: When the IP-6610 bridge CRC is on, it will bring MAC CRC32 checksum with data. When
the IP-6610 bridge CRC is off, it will delete the CRC32 checksum.
Parameters: setting On/off
Command: >set bridge age
Syntax: set bridge age time
Explanation: The IP6610 provides Layer-2 bridging by automatically learning the MAC addresses of
subscribers and forwarding only those packets destined for the service side. MAC tables
support up to 16K MAC addresses. By utilising a configuration aging mechanism MAC
address entries are automatically deleted if no frames are received from a particular station
for a the aging period.
Parameters: age MAC aging time in seconds (10~1000000)
Command: >set dhcp domain_name
Syntax: set dhcp domain_name name
Explanation: User this command to specify a domain name for dhcp client in the global configuration,
Parameters: name specifies the client’s domain name string
Idle Flag DA SA DATA CRC32 CRC16 IdleFlag
To Next Page
Loading...
