Loop Telecom IP6610 - Page 87

Chapter 14 SNMP Configuration Setup
64
Set the SNMP community. Key in the admin command set snmp community public. Then press the
Enter key
Set the SNMP contact. Key in the admin command set snmp contact, then press the Enter key. Key in
your contact information. Press the Enter key again. The sample screen below shows the information we
keyed in.
Set the SNMP location. Key in the admin command set snmp location and then press the Enter key.
Key in your contact address and then press the Enter key again. The sample screen below shows the
information we keyed in.