Chapter 6. Panel Editor
6-83
1) Trigger Condition
Specifies an activating condition of calculation function.
Condition Description
Always Operates at every scan.
On Operates once at the rising edge of trigger device
Off Operates once at the falling edge of trigger device
Toggle Operates at the rising and falling edge of trigger device
During On Operates at every scan during the trigger condition is On
During Off Operates at every scan during the trigger condition is Off
2) Trigger Address
(1) Specifies the address of trigger device (Bit device).
(2) Refer to the section 6.9.3 Button Tag for details to specify the address.
3) Operand Address
(1) Specifies the address of the device used in calculation and the address of the device where calculation results are to be
saved.
(2) If Constant is selected, the address window will disappear and a constant can be specified.
(3) See ‘6.9.1 Numeric Tag’ for details on Setting Address.
4) Operator
(1) Specifies an operator.
(2) Operators available are as follows.
Operator Description
+ Adds operand 2 to operand 1.
- Subtracts operand 2 from operand 1.
x Multiplies operand 2 with operand 1.
/ Divides operand 1 by operand 2.
To Next Page
Loading...
Need help?
General
