Chapter 8. Communication Driver
8-12
8.6 LS MASTER-K500H/1000H : Dedicated Protocol
8.6.1 Communication Mode
Connection is available through LS MASTER-K500H/1000H PLC and the Dedicated Protocol.
If connected with LS MASTER-K500H/1000H and the Dedicated Protocol, its applicable communication setting is as follows.
At this moment, the applicable communication setting of PLC and the XGT Panel to be connected between should be set identical
to each other.
Setting Contents
Setting Item
CH 1 CH 2
Remarks
Communication
Mode
RS-232C RS-422, RS-485 -
Instrument Sided
Connector
9-Pin Male connector 25-Pin Male connector -
Connection
Protocol
Dedicated Protocol -
Communication
Speed
1,200/2,400/4,800/9,600/19,200bps -
Data Bit 8Bits -
Parity Bit None -
Stop Bits 1 Bit -
Station No. 0 ~ 31
Station No. unavailable if
identical to the XGT Panel
8.6.2 Connection Available Device
The range of the connection available device if connected with LS MASTER-K500H/1000H is as follows
Max. range of the connection available device is diverse based on the connected type of PLC.
Max. available range is displayed in here. For more information on the Max. device range of each PLC, refer to the user’s
manual of the applicable PLC.
Connection Available Area
Device
Bit Word Long
Remarks
D Area -
D0000 –D4999 D0000 –D4998
Bits Read
unavailable
T Area
T0 –T255 T0 –T255 T0 –T254
-
C Area
C0 –C255 C0 –C255 C0 –C254
-
P Area
P000 –P63F P00 –P63 P00 –P62
Ex.) P0F :
P0’s bit 15
M Area
M0000 –M191F M000 –M191 M000 –M190
-
L Area
L000 –L63F L00 –L63 L00 –L62
-
K Area
K000 –K31F K00 –K31
K00 –K30
-
F Area
F000 –F63F F000 –F063
F000 –F062
Read dedicated
S Area -
S00 –S99
S00 –S98
Bits Read
unavailable