Chapter 8. Communication Driver
8-8
8.4 LS MASTER-K10S1 : Dedicated Protocol
8.4.1 Communication Mode
Connection is available through LS MASTER-K10S1 PLC and the Dedicated Protocol.
If connected with LS MASTER-K10S1 and the Dedicated Protocol, its applicable communication setting is as follows.
At this moment, the applicable communication setting of MASTER-K10S1 and the XGT Panel to be connected between should be
set identical to each other.
Setting Contents
Setting Item
CH 1 CH 2
Remarks
Communication
Mode
RS-232C
(232/485 converter necessary)
RS-422, RS-485 -
Instrument Sided
Connector
Terminal plate Terminal plate or connector -
Connection
Protocol
MASTER-K Dedicated Protocol -
Communication
Speed
1,200/2,400/4,800/9,600/19,200bps -
Data Bit 8Bits -
Parity Bit None -
Stop Bits 1 Bit -
Station No. 0 ~ 31(1F)
Station No.
unavailable if
identical to XGT
Panel
8.4.2 Connection Available Device
The range of the connection available device if connected with K10S1 is as follows.
Connection Available Area
Device
Bit Word Long
Remarks
D Area -
D0000 –D0063 D0000 –D0062
Bits Read
unavailable
T Area
T0 –T47 T0 –T47 T0 –T46
-
C Area
C0 –C15 C0 –C15 C0 –C14
-
P Area
P00 –P1F P00 –P01
P00
Ex.) P0F :
P0’s bit 15
M Area
M00 –M15F M00 –M15 M00 –M14
-
L Area
L00 –L07F L00 –L07 L00 –L06
-
K Area
K00 –K07F K00 –K007
K00 –K06
-
F Area
F000 –F15F F000 –F015
F000 –F014
Read dedicated
S Area -
S00 –S15
S00 –S14
Bits Read
unavailable
To Next Page
Loading...
Need help?
General
