Chapter 7. XGT Panel Function
7-3
0-ON :05/01/07 14:08:10
OFF:05/01/07 14:10:10
1-ON :05/01/07 14:13:17
OFF:05/01/07 14:16:18
2) Check Specific Alarm List
(1) Locate the cursor on Specific Alarm List and press ENT key to display the screen showing the type of the alarm presently
selected as shown below.
(2) Press S and T keys to move to ID of the alarm history to check and then press ENT key to display the history of
the applicable alarm occurred as shown below.
(3) Returning to the Operation Mode is identical to ‘1) Check All Alarm List’.
3) Delete All Alarm List
(1) Deletes all the alarms saved in the XGT Panel.
(2) Locate the cursor on Delete All Alarm List and press ENT key to display the confirmation screen as below.
(3) Move the cursor on ‘Yes’ and press ENT to delete All Alarm List. Pay attention! If the Alarm List is once deleted, it is
not possible to recover.
Are
ou sure?
Yes.
Delete Alarm List!
02: Tank1Water excessive
00: Tank1Water insufficient
03:
Sensor 1 Damaged
01: Boiler 1 Overheated
Alarm Message
Alarm ID
No.
To Next Page
Loading...