Chapter 4. System Configurations
4-4
For 1:N connection of Ch2, select .
In the Communication Properties window, set Configuration as 1:N.
If setting is completed, XGT Panel is ready to communication with the controller connected at each channel.
In order to communicate, select channel and station at the tag setting window like figure below.
(Ch1 is deactivated because that is set as Not used.)
If setting is done like above figure, XP10 can read/write data of device D0 of MASTER-K whose station no. is 0.
(Detail function is different according to tag type.)
To Next Page
Loading...