Chapter 6. Panel Editor
6-7
(2) The ‘Delete Screen’ item is selected, the screen is deleted from the project.
However, the last screen cannot be deleted if there is only one screen left because the project should have at least
one screen.
3) Cut, Copy, Paste
This section describes how to ‘Cut’, ‘Copy’, ‘Paste’ in the Project Window.
(1) Place the mouse pointer on the item to cut and copy and click the right mouse button, then the pop-up menus shown below are
displayed.
(2) The selected screen is cut when the ‘Cut’ item is selected. If ‘Copy’ is selected, the selected screen is not cut but copied.
(3) The cut or copied screen can be pasted to a new project.
To Next Page
Loading...
Need help?
General
