Maeda MC-305C-2 - Starting Moving Machine

3-71
2.6 STARTING MOVING MACHINE
• Do not allow anyone to come around the machine.
• Put away all the obstacles on the traveling path.
Check for projections and grooves on the traveling path especially when going backward. Fix
the traveling path.
• Check the safety around the machine and honk a horn before starting moving the machine.
• Adjust the engine speed to low and operate the left and right traveling levers slowly at the
same time. Check the traveling speed of the machine.
Do not make sudden start especially when you are going backward. You can cause serious
accidents.
• The front of the machine will be the blind corner. Be extremely careful when moving forward.
• If you cannot verify the safety because the driving direction is the blind corner, stop driving
and check the safety in the traveling direction. Staff a guide person if necessary depending on
the work site situation.,
• Operate the work selector switch to the “TRAVEL” position and the traveling lock lever to the
“TRAVEL” position.
[PREPARATION BEFORE STARTING MOVING]
1. Operate the work selector switch on the outrigger operation
panel to the “TRAVEL” position.
2. Push down the traveling lock levers (8) to the “TRAVEL”
position.
[1] MOVING FORWARD
Operate the left and right traveling levers at the same time.
• Push the left and right traveling levers slowly forward to move
forward.
[2] MOVING BACKWARD
Operate the left and right traveling levers at the same time.
• Pull the left and right traveling levers slowly toward you to move
backward.